Turn the camera On and Off:

To turn the camera on – Long press the Power/Mode button. The indication light will light up blue (3-5 seconds) and then blink white 3 times. You will hear 3 beeps when the camera is ready. The indication light will remain white when the camera is turned on and ready to capture.

To turn the camera off – Press the Power/Mode button for 3 seconds. You will hear 3 beeps and the indication light will blink before turning off completely.

Camera reset:

Press and hold the power button for 30 seconds while the camera is On. This will force the camera to reset and start over. This can be used in a situation where the camera is not responding.

Camera factory reset (firmware is reset as well):

Press and hold the power and recording button for 30 seconds while the camera is On. This will force the camera to reset into factory settings and will remove any firmware update that was installed. This can be used if something went wrong during or after a firmware update.

NOTE: Camera buttons are disabled automatically while the camera is connected to a mobile device via wifi.

Did this answer your question?